Scheibenwaschanlage Behälter

Dodge-Forum

Help Support Dodge-Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Registriert
05. Juli 2014
Beiträge
119
Reaktionspunkte
0
Ort
Bochum
Mahlzeit jemand ein Plan wie ich den Behälter für Wischwasser tausche ? Ram Gen4 Bj 2009 5.7 Hemi

Danke gruss aus Bochum

Und wo ich gegebenfalls neuen bekomme !
 
Neuer Behälter z.B. hier: https://www.rockauto.com/de/catalog...asher,windshield+washer+fluid+reservoir,10585
Ausbau:
1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir (1) into a clean container for reuse.
3. Remove the grille from the front of the vehicle.
4. Remove the two screws (5) that secure the inboard washer reservoir mounting brackets at the top and bottom members of the Front End Module (FEM) carrier (also known as the radiator closure), just to the left of the cooling module.
5. Pull the washer reservoir upward far enough to disengage the two mounting tabs (2) on the outboard side of the reservoir from the two slotted loops integral to the FEM carrier.
6. Disconnect the FEM wire harness connector (3) from the washer pump/motor unit connector receptacle on the top of the motor housing.
7. Disconnect the reservoir washer hose (4) from the barbed pump outlet nipple of the washer pump/motor unit.
8. Disengage the reservoir washer hose and FEM wiring bundle from the routing trough integral to the front of the reservoir.
9. Rotate the outboard side of the washer reservoir (3) away from the FEM carrier far enough to access and disconnect the FEM wire harness connector (1) from the washer fluid level switch connector receptacle (2) on the back of the reservoir.
10. Remove the washer reservoir from the left side of the FEM carrier.
 

Anhänge

  • 2069529.jpg
    2069529.jpg
    59,2 KB · Aufrufe: 100
  • 1209619.jpg
    1209619.jpg
    43 KB · Aufrufe: 109
Oben